Water Heater Heat Element Test

Remove the upper access panel screws first on the electric water heater with a screwdriver.

Water heater heat element test.

There should be two panels on your water heater an upper and lower. This is the most important step you should always take while testing or cleaning any kind of. Even without that level of detail there is a simple test you can perform to see if an electric water heater heating element is in good working order. Remove the access panel cover.

If the heater is an electric unit. It s necessary to do this so that you re testing the conductivity of only the element itself and not any other connected. Turn off electrical power to the water heater you should have done this earlier if you read the instructions above. Remove the insulation and disconnect the electrical wire at the terminal and use your multimeter to test the electrical flow.

Make sure you test both screws on the face of. How to check a heating element in a water heater step 1. Touch the other probe to any metal part of the water heater. If the multimeter needle moves the heater element is grounded and it must be replaced.

Steps for water heater element testing turn the breaker off. Determine which of the two heating elements in your water heater could be the problem by turning on the water at.